AIO Toothpick 13A (25.5*25.5mm)
Model: GOKU GN413S
IMU: MPU6000 gyro/accelerometer (SPI)
OSD: BetaFlight OSD w/ AT7456E chip
black box: 8M
BEC Output: 5V@2A
Integrated LC Filter
Firmware target: FLYWOOF411
ESC MCU: BB21F16G
Continuous current: 13A
Supports Dshot600 ,Oneshot,Multishot
Size: 34×34mm board,25.5mm mounting holes (M2)
Board is great! but inav firmware 2.5.2 doesn't support FPORT - or its broken..
For a F4 board Fport is a must it you want telemetry without wasting an UART.
and for the previously 2.3.0 inav firmware that was posted here - Fport worked! but motor 1 was not working..
it does work fine with latest betaflight releases, but theres not much use for the BARO in that case...
Its a great board but it could be so much better with the right software support..
Used the flight controller for a light weight 3d printed 3inch quadcopter in combination with 1104 motors. It worked perfectly out of the box. The solder pads are easily accessible. A nice feature is the on board barometer which gives you an indication of the height you're flying at!
Very Happy. Easy to solder, to configure. Lightweight...
I build this little one:
Ordered this board for a tiny trainer works great! The first board I received had some defects that must have gotten past quality control (led just fell off before the first flight, bad motor solder pads). After a few emails and pictures showing flywoo the oversight they sent a new board that worked great! Will definitely buy from flywoo again.
Good product and service
Payment & Security
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.